Viking Repair Service Phoenix, AZ
(480) 605-0709
Index

Crew on the road 8:00 am – 8:00 pm, seven days. Line answered 24/7.

03 Phoenix, AZ · Viking only

Oven Repair

Bake elements, sensor calibration, hinges and controls on Viking wall ovens and range ovens.

Stainless gas range with its oven door lowered on an empty cavity, one wire rack leaning against dark cabinets

02 Said on the phone

Any one of these is enough to work with.

  • Set to 350 but roasting as though it were 300
  • Bake side dead while the broiler still works
  • Convection fan howling or grinding partway through a cycle
  • Door will not pull shut and heat escapes into the cabinet

What changed, and roughly when it changed, is worth more to us than a guess at the part. Say it in your own words — nobody here needs the correct term for it.

03 On the meter

What gets measured before a part is named.

Cavity temperature against the setpoint
Our own probe on the centre rack through a preheat and two full cycles, written down beside what the panel claims. An oven roasting as though it were fifty degrees cooler is a sensor or a stored offset four times out of five.
Current on the bake circuit
A clamp on the element while it is hot, then the relay that feeds it. A dead bake side with a working broiler is either an open element or a relay that has stopped pulling in, and the reading says which before the back panel comes off.
Hinge tension and the top corner gap
Spring tension measured on both sides and the gap along the top edge checked cold. A door that will not pull itself shut leaks heat into the cabinet and then shows up as a slow oven on every other test you run.

04In their words

Oven Repair calls, in the customer’s words.

Three Phoenix jobs on this side of the kitchen: what it was doing, what it turned out to be, what it took.

4.9 / 5824 reviews

  • Broiler worked, bake did nothing at all. He traced it to a burned contact on a control relay and rebuilt that board rather than replacing the whole assembly. Roast chicken again by Sunday.

    Yesenia B.Alhambra

  • The upper door would not close flush and heat was leaking into the cabinet. Hinge springs had stretched. He replaced both sides, reset the door, and checked the seal all the way round with paper.

    Thaddeus V.South Mountain

  • Cookies burned underneath and stayed pale on top in the lower oven. He probed the cavity through a full cycle and caught the bake element shorting intermittently. Replaced it, then retested before writing anything up.

    Priya H.Estrella

Every job above was run by this workshop in Phoenix.

05 The number

What oven repair costs here.

Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.

Igniter or burner assembly
$170–$420
Oven thermostat or heating element usually this repair
$210–$440
Refrigeration fan or defrost system
$280–$620
Dishwasher pump or control
$190–$390
Control board or touch panel usually this repair
$470–$630
Compressor or sealed-system repair
$1,470–$2,980

Parts and labour, quoted as the band your fault sits in and agreed out loud before anything is dismantled — and the $89 service call comes off that figure once you approve the work. Where a job crosses two bands, you hear both numbers on the phone, not on the invoice.

Talk it through on (480) 605-0709

08 Book the visit

Oven Repair today, if the slot is there.

Tell us the model and serial number off the plate and what the machine is doing. Most oven repair faults narrow to two or three candidates before anyone gets in the van, which is how the right part ends up on board.

(480) 605-0709 Pick a window online

8:00 am – 8:00 pm, seven days · line answered 24/7