Viking Repair Service Phoenix, AZ
(480) 605-0709
Index

Crew on the road 8:00 am – 8:00 pm, seven days. Line answered 24/7.

04 Phoenix, AZ · Viking only

Dishwasher Repair

Drain, spray-arm, heating and leak diagnosis on Viking integrated and panel-front dishwashers, hard-water scale included.

Built-in dishwasher pulled forward with its lower panel off, showing the pumps, sump and drain hose

02 Said on the phone

Any one of these is enough to work with.

  • Water left standing in the sump when the cycle ends
  • Glassware coming out chalky with mineral film
  • Water tracking out under the door onto the floor
  • Cycle stalling partway with the panel lights blinking

What changed, and roughly when it changed, is worth more to us than a guess at the part. Say it in your own words — nobody here needs the correct term for it.

03 On the meter

What gets measured before a part is named.

Fill, drain, then the check valve
Inlet flow timed into a jug, float and pressure switch continuity, drain pump current, and whether the check valve is seating at all. Water standing in the sump is a blocked path much more often than a pump that has given up.
Water temperature and cycle steps
Thermistor resistance against a probe in the sump while the board walks through the cycle. A wash that stalls halfway with the lights blinking is usually waiting on a temperature it is never going to reach.
Scale, arms and the door seal
Spray-arm bearings and jets, the filter stack, and the gasket along the bottom of the door. On this water, chalky glassware and a slow drain are the same fault caught at two different ages.

04In their words

Dishwasher Repair calls, in the customer’s words.

Three Phoenix jobs on this side of the kitchen: what it was doing, what it turned out to be, what it took.

4.9 / 51,630 reviews

  • Standing water in the bottom at the end of every cycle. He opened the sump, found a chip of glass wedged in the impeller, and cleared it. Charged the $89 call and nothing else.

    Bartolo M.Alhambra

  • Ours is wedged into a bungalow galley, so getting it out is half the job. He managed it without marking the woodwork, found the drain hose kinked behind, and rerouted it. Drains in seconds now.

    Lorne K.Garfield

  • Cycle stalled partway and the panel lights blinked at us. A float switch sticking with mineral crust. He cleaned and tested it, then ran a cycle through. Fine now. He came at the very end of the window.

    Griselda A.South Mountain

Every job above was run by this workshop in Phoenix.

05 The number

What dishwasher repair costs here.

Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.

Igniter or burner assembly
$170–$420
Oven thermostat or heating element
$210–$440
Refrigeration fan or defrost system
$280–$620
Dishwasher pump or control usually this repair
$190–$390
Control board or touch panel usually this repair
$470–$630
Compressor or sealed-system repair
$1,470–$2,980

Parts and labour, quoted as the band your fault sits in and agreed out loud before anything is dismantled — and the $89 service call comes off that figure once you approve the work. Where a job crosses two bands, you hear both numbers on the phone, not on the invoice.

Talk it through on (480) 605-0709

08 Book the visit

Dishwasher Repair today, if the slot is there.

Tell us the model and serial number off the plate and what the machine is doing. Most dishwasher repair faults narrow to two or three candidates before anyone gets in the van, which is how the right part ends up on board.

(480) 605-0709 Pick a window online

8:00 am – 8:00 pm, seven days · line answered 24/7